Click on the image to enlarge

Turborix 25A Brushed Motor Electronic Speed Controller
Model Number : rcps51601

You are buying a Brand New Turborix 25A Brushed Motor Electronic Speed Controller. It is great for small to large parkflyers. It can drive brushed (DC) motors up to 480 (280, 350, 370, 400 and 480) with ease. If you build and fly many parkflyers, your may wish to buy a few of these as you can't find a ESC at such a bargain price.

This ESC is perfect for scale planes, as it operates in a scale like manner. The motor starts when you press the button and will only shut down when the voltage level drops below 5 volts. So cutting off the throttle lets you idle the motor, simulating a real airplane engine (or glow engine).

You should install the button on the side of the plane, where you can press it just before launching your plane.

Once you start the motor by pressing the arming button, the motor will not stop until the battery voltage falls under 5v - cutting the throttle will have the motor rotating at low rev. simulating engine idling.

	Weight: about 15 grams with wires, plugs and switch
	Current: Continuous current rating of 25A (Max. short burst of 50A)
	Input Voltage: 7.2-12v
	Features: Battery Eliminator Circuit (BEC) to power receiver and up to 3 micro/mini servos,
	Throttle control: Liner
	Safety: Arming switch (press to start motor) Automatic cut off: 6v to leave enough power for the radio to allow for a safe landing
	Perfect for 7/8 NiCad/NiMh cells or 2 LiPol cells Ideal for motors up to size 480 type motors
	Size: Fits in to a 28x13mm opening that is 20mm deep
	Servo Connector (suits JR, Hitec, Futaba etc.)
	Power Connector: Mini Tamiya style
	Note: The lose wires connect to the motor and the wires with mini Tamiya connector connect to the battery - incorrect connections will permanently damage the unit or other components
	Note: Not compatible with Sanwa/Airtronics gear (required rewiring the connector)

Turborix 25A Brushed Motor Electronic Speed Controller